How Often Do I Need To Grease Or Oil Mechanism In Meyer Hotshot Walk Behind Spreader?
Published 10/06/2025
Question:
How often do I need to grease or oil parts on the stainless ME63FR?
asked by: Tom
0
Expert Reply:
Tom, for the # ME63FR, Meyer recommends greasing the axle bearings and oiling the impeller shaft bearing, pivot points, and spring behind the rate plate every few uses - more often if you’re out daily in rough elements.
The stainless frame keeps corrosion off the main structure, but the moving parts still need that little TLC and lubrication.
Do you spray any anti-corrosion product on the spinner or gears too?
expert reply by:
Andrew N
0
Product Page this Question was Asked From
Meyer Hotshot 70 HD Broadcast Salt and Fertilizer Spreader - Walk Behind - Stainless Steel - 70 lbs
- Salt Spreaders
- Walk Behind
- Salt
- Fertilizer
- 12 Foot Spread
- 31 cu ft or More
- Meyer
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How Far Will Meyer Walk Behind Spreader Be Able To Throw Salt Or Fertilizer?
- Q&A: Is There Any Maintenance Difference Between Meyer Walk Behind Spreader ME43FR & ME63FR ?
- Q&A: Which Tailgate 2" Receiver Mounted Salt Spreader Is Going To Work With Wet Sand / Salt Mixes ?
- Q&A: Which Meyer Tailgate Salt Spreader Has A Better Brush Auger To Keep Salt Spreading Evenly?
- Q&A: How Does The Controller And Settings Differ Between Meyer Base Line And Blaster Salt Spreaders?
- Q&A: Do Meyer Tailgate And Hitch Mount Salt Spreaders Come With Vibrators To Prevent Clogging?
- Q&A: How Can I Get Trailer Lights to Flash when Disconnected from Truck
- Article: Thank you!