Will It Draw Too Many Amps If I Run 2 12V LED Lights On Porch Of Enclosed Trailer?
Published 09/04/2025
Products Featured in This Question
Question:
Will it be too much draw to add two of these M357FR off my trailer’s existing porch-light switch? going on enclosed trailer
asked by: Dana
Expert Reply:
You’ll be fine on draw - LED utility lights pull modest current compared to incandescent. This particular 12v model # M357FR pulls only about 4 amps, so 2 of them would be 8 which is good for a circuit rated for 10a or more (most are rated for that). Just ensure your switch/wiring are in good shape and are wired for 12v, not 110.
If it's 110 you'd instead need # M337FR which actually only pulls about .5 amps since it's running on higher voltage.
Product Page this Question was Asked From
Exterior LED Utility Light - Flush Mount - Powder Coated Aluminum - Clear Lens - 12V DC - Silver
- Work Lights
- Utility Lights
- Exterior Lights
- Rectangle
- Recessed Mount
- LED Light
- White
- M-3 and Associates
more information >
Continue Researching
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: LED Flood Light Recommendation for Lighting Ramp at Rear of Trailer
- Q&A: Replacement Trombetta Polarity Reversing Solenoid for Hydraulic Slide-Out on RV
- Q&A: Replacement Trailer Clearance Lights PM-108-15 SAE-AP2-79
- Q&A: Replacement Microwave for High Pointe EM925BSC in a 2008 Dutchmen Victory Lane
- Q&A: How To Wire the Exterior LED Utility Light Part M337FR
- Q&A: Replacement Interior LED Lights For a Liteco 179 Florescent Light Fixture
- Article: How to Change a Trailer Tire
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Measure for Trailer Hitch Drop
- Article: Pintle-Hitches
- Article: How to Measure for Motorhome Steps