Do The Wires On The Blazer LED Off-Road Light Bar BL93VR Need To Be Run To The Remote Box?
Updated 10/22/2025 | Published 04/08/2025
Question:
Do the wires on the light still have to be ran from the rollbar to the remote box in the engine bay?
asked by: Brian W
0
Expert Reply:
Hello Brian, you are correct. The wires on the Blazer LED Off-Road Light Bar # BL93VR do need to be run from the light to the remote module. It comes with 9' of wire which should be more than enough for any application.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Blazer LED Off-Road Light Bar - Remote - 6,090 Lumens - Mixed Beam - Double Row - 25-3/4" Long
- Off Road Lights
- Light Bar
- LED Light
- Single Light
- 25-3/4L x 3-1/2T x 2D Inch
- Universal Mounts
- Combo Beam
- Blazer
more information >
Continue Researching
- Q&A: What Is The Difference Between the 6K and 7K Dexter Axle Electric Brake Assemblies
- Q&A: Replacement Tire and Wheel for Karavan Trailer 2990-72-12
- Q&A: Recommended Disc Brake Conversion for 7,000 lb Dexter Axles
- Q&A: 5th Wheel Landing Gear Motor Makes Loud Clicking Noise and Will Not Raise Trailer
- Q&A: Can a Single Motor Venture Landing Gear Set be Converted to a Dual Motor System
- Q&A: Troubleshooting Powered Landing Gear that Clicks But Does not Raise/Lower
- Q&A: What Tool is Needed to Remove the Castle Nut on a Trailer Axle
- Article: Trailer Wiring Diagrams
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
Jesse M.
10/22/2025
Hey Brian, how did running the wires from the Blazer light bar to the remote module go? Your update could make it easier for the next person wiring the same setup.