Dimensions of the Ball Platform of the Curt Vertical Ball Mount # D55007
Published 06/11/2014
Question:
What are the dimensions of the piece that the ball hole is in? I have a cooler rack that wont accept anything larger than 2inch wide.
asked by: Mark
1
Helpful Expert Reply:
I went out into our warehouse and measured the ball platform of the Curt Vertical Drawbar part # D-55007 and found it to be 4-1/2 inches by 2 inches.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Drawbar for Curt Vertical Trailer Hitch Recievers
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- Steel Shank - Gloss Black
- Drop - 0 Inch
- Rise - 0 Inch
- Fits 1-1/4 Inch Hitch
- 3500 lbs GTW
- Vertical Ball Mount
- CURT
more information >
Continue Researching
- Q&A: Dimensions Of Curt Drawbar # D-55007 To Verify Fitment With Receiver
- Q&A: Hitch and Wiring for 2013 Lexus GX 460
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: How Much Slack Is Needed In Trailer Wire Connection To The Tow Vehicle?
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What are the Differences in the AM20334 and the AM20304
- Q&A: High-Rise Hitch Ball to Increase Height for Motorcycle Towing Camper Trailer
- Q&A: Avaialbility Of Trailer Hitch For 2000 Toyota Granvia/Grand Hiace
- Article: My Trailer Hitch Doesn't Fit
- Article: Ram Trailer Tow Prep Package