Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 Measurements
Updated 10/30/2025 | Published 02/13/2025
Question:
Could you give me the measurement from the section that mounts to the bottom of the I Beam to the last hole at the bottom? And to the Bottom of the bracket?
asked by: Timothy
Expert Reply:
Hey Timothy! The distance from the center hole on the upper bracket arms down to the center of the bottom hole on the # LC349975 is 11-1/4". From the same upper hole to the bottom of the entire bracket is 11-3/4". The distance from the bottom of the upper bracket arm to the center of the bottom hole is 9-15/16". The distance from the bottom of the upper bracket arm to the bottom of the entire bracket is 10-7/16". If you need anything else let me know in the comments below.
(click to enlarge)
Product Page this Question was Asked From
Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Brackets
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Best Replacement For Older Dometic Duo Therm 57915.531 Ducted Single Zone AC System With Furnace
- Q&A: Availability Of Shorter Stabilizing Jack For Lippert Ground Control 3.0 Leveling System
- Q&A: Torque Spec For Grade 8 Bolts On Lippert 6-Point Leveling System
- Q&A: Replacement Air Conditioner for RV Duo Therm 57915.531
- Q&A: Determining The Correct Replacement Entry Lock For A 2008 Fleetwood Bounder 38V
- Q&A: Correct Breaker Size for Replacement 6-Point Controller for Lippert Components Ground Control 2.0
- Q&A: Recommended Electric Winch for Raising and Lowering a Pop Up Camper
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Best Landing Gear
- Article: Trailer Wiring Diagrams
Robin H.
10/30/2025
Hey Timothy, did those bracket measurements give you what you needed for your setup with the I-Beam jack bracket? Your update could make it easier for the next person working on the same fit.