How to Find the Reverse Light Circuit on a 2013 Nissan Versa
Updated 06/09/2014 | Published 06/07/2014
Question:
What color is the reverse wire at the tail light in a 2013 nissan versa . One side is out . I changed the bulb and that is not the problem.
asked by: Rob
0
Expert Reply:
The best way I could recommend you determine which wire is the reverse light circuit is of tail light wiring harness for your 2013 Nissan Versa would be to use a circuit tester like part # PTW2993 to test all of the wires of the harness while the vehicle is in reverse with the key on. I would recommend doing this on level ground with the emergency brake on.
expert reply by:
Jameson C
0
Continue Researching
- Q&A: Can a 4-Way Trailer Connector be Plugged Into a 5-Way Vehicle End Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Q&A: Wiring New 4-Way Connector on Trailer with 5 Wires
- Article: Trailer Wiring Diagrams
- Q&A: New Brake Assemblies, Hub/Drums, Brake Lines, and Bearing Buddy for Trailer with 3,500 lb Axle
- Q&A: How to Identify Correct Replacement Bearings and Seals for Boat Trailer
- Q&A: Recommended Disc Brake Conversion Kit for 5200-lbs Lippert Axles with 6 on 5-1/2 Bolt Pattern
- Q&A: Where To Attach Blue Wire From 5 Wires on Trailer When Installing a 7-Way Connector
- Q&A: Can a 5-Way Adapter Work with a Trailer 4-Way Connector
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)