Will GearSpace 34 Enclosed Cargo Carrier Fit on 2021 F-450 with Lance 1172 Truck Bed Camper?
Updated 11/03/2025 | Published 01/06/2025
Question:
I have a 21 f450 with a lance 1172 truck camper. Wondering if this will work with the slide at rear of camper? Thanks
asked by: Rick
Expert Reply:
Hey Rick, thanks for reaching out!
The GearSpace 34 Enclosed Cargo Carrier # HGK826 sits 10" out from the center of the hitch pin hole (31" when you slide it out). I'm not sure what kind of clearance your Lance 1172 camper needs, but if you measure out at least 10" out from your hitch pin hole and it clears the back end of the camper you'll be good to go!
What are you planning on using the extra cargo space for?
(click to enlarge)
Product Page this Question was Asked From
GearSpace 34 Enclosed Cargo Carrier for 2" Hitch - Slide Out - 34 cu ft - 300 lbs - Light Gray
- Hitch Cargo Carrier
- Enclosed Carrier
- Slide-Out Carrier
- Hitch Mount
- 300 lbs
- Fits 2 Inch Hitch
- 68 Inch Long
- Cargo
- Plastic
- Lets Go Aero
more information >
Continue Researching
- Q&A: Is there a Light Kit for the etrailer Hitch Cargo Carrier Cage Kit e42MV?
- Q&A: Recommended Swing Away Hitch for a Toyota Sienna
- Q&A: Is a P-Trap Needed When Using the Camco RV Drain Trap
- Q&A: Is 24x60 etrailer Enclosed Cargo Carrier Rated for Class C Motorhome
- Q&A: Can I Add Swing Away Arm To Lets Go Aero GearSpace 34
- Q&A: Largest Hitch Mount Enclosed Cargo Carriers
- Q&A: Comparing O-Track Cargo Control System And L-Track System
- Article: Rooftop Cargo Carriers
- Article: Roof Rack Information
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Lighting Requirements
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Determining Trailer Tongue Weight
- Article: Calculating Portable Generator Power Needs
Jon G.
11/3/2025
Hey Rick, how did your measurements turn out with the GearSpace 34 and the rear slide on your Lance camper? Once you checked that clearance, did it look like the carrier would fit without interference? Your update could make it easier for others with a similar setup.