How Wide are the Tracks for the etrailer Easy Carry Trailer Ramps
Updated 11/17/2025 | Published 12/11/2024
Question:
How wide are the tracks?
asked by: Rusty
0
Expert Reply:
Hey Rusty,
The track section is 11-3/4" wide for the etrailer Easy Carry Trailer Ramps # FHG55ZR, and then each panel is 4-3/4" long with a 2" gap between each of them.
expert reply by:
Jon G
0
Product Page this Question was Asked From
etrailer Easy Carry Trailer Ramps - Aluminum - 5' x 14-1/2" - 6,000 lbs
- Car Ramps
- Loading Ramps
- Car Hauler Ramps
- 6000 lbs
- Strap-On
- 14-1/2 Inch Wide
- 60 Inch Long
- Aluminum
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Which RapidRamps Bolt On Trailer Ramp Kit Is Best For My Car Hauler Trailer?
- Q&A: Do The 5 Foot etrailer RapidRamps Have Same Strength And Weight Rating As 6 Foot Ramps?
- Q&A: Upgrading Heavy Angle Iron Ramps On Trailer To Bolt-On Folding Aluminum Ramps
- Q&A: Bolt On Aluminum Ramp Kit For Trailer That Uses Heavy Angle Iron Ramps That Are Not Long Enough
- Article: Holiday 2025 | Best Gifts for Towers
- Q&A: Brake Controller Wiring Harness on 2026 Ford F-250 WT
- Q&A: Can Aluminum Trailers Ramps In RapidRamps Kit Be Adjusted For Different Width Vehicles?
- Q&A: Do etrailer Easy Carry Trailer Ramps Bend
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Charge a Dump Trailer Battery
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Slipper Spring Trailer Suspension System Review
Jon G.
11/17/2025
Hey Rusty, did those track measurements work out for your trailer ramps? Knowing how they fit could help others figure out if this setup will suit their trailers too.