Hitch Step Recommendation for a 2013 Chevy Silverado with a Class IV Hitch and Reducer
Updated 06/02/2014 | Published 05/30/2014
Question:
I have a 2013 chev 3/4 ton that now has a 3inch receiver, it does come with a reducer that allows 2inch receivers to be used, but the hitch step I previously used on my 01 truck does not extend far enough into the hitch to be locked by the new deeper position of the pin that the 3inch hitch has when using the reducer.. does you 2inch hitch steps work on this configuration that they now use for 2013?
asked by: Bill R
Expert Reply:
Check out the Tube Stainless Steel Trailer Hitch Receiver Step # CR-605, this has 3 different holes that can be used to pin the step to the hitch so it should work very well for your 2013 Chevy Silverado with a Class IV hitch.
Product Page this Question was Asked From
Carr Hitch Mounted Step for 2" Trailer Hitches - Black Powder Coat Aluminum - Reflective Finish
- Hitch Step
- Flip-Down Step
- Smooth Step
- 2 Inch Deep
- 650 lbs
- 2 Inch Hitch
- 5 Inch Wide
- Aluminum
- Carr
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Hitch Step for Climbing Into the Back of a Vehicle
- Q&A: What Is the Width of the TruXedo TruXport Soft Roll Up Tonneau Cover for a 1999 Ford F-150 and 250
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommendation for a Tonneau Cover for a 1999 Ford F-150 Flareside
- Q&A: Replacement Tarps for TruXedo TruXport & Lo Pro QT Tonneau Covers on 1998 Ford F-150
- Q&A: Replacement Axle, Brake Assemblies, And Hubs And Drums For M1101 Trailer
- Q&A: Which is Best Brand of Trailer Brake Assemblies
- Article: Performance Chips and Modules
- Article: Trailer Wiring Diagrams