Where is the On Off Switch on the 701 LED Solar Motion Light

Question

Question:

Where is the light on off switch location on my701 LED solar motion light. I bought it and mount on a tree. I know that sounds like a weird location. But it needs to light a entry for a shed. It seems to be the best location.

asked by: Roger

0

Expert Reply:

Hello Roger.

On the ATAK Solar Motion Light - Weatherproof - 460 Lumens # PT701, there is a switch/button located on the back. I have attached a picture so you can see where it is located.

expert reply by: Kate F

0

Motion Light On Off Button
(click to enlarge)

Answer 1

I really like the solar powered LED Porch Light for RVs #DG0132 which mounts to the side of your RV and gives you a light that's motion activated, is waterproof, and since it's solar powered it provides it's own power source. It produces…

view full answer...

Answer 2

I called the manufacturer and confirmed that the Solar Powered Outdoor Light for RVs #DG0132 does indeed have a on/off switch. The dimensions are 6" L x 3.75" W x 3.25" H.

view full answer...

Answer 3

If you had the ATAK Solar Motion Light #PT701 installed on a vehicle or camper and it wasn't turned off then it would detect motion while you were driving and turn on while driving at night, so you would want to turn it off when driving. Using…

view full answer...

Answer 4

Thank you for the photos, that really helps! It looks like you're needing the 1-diode 2-1/2" round lights from Optronics; Red #MCL0040RBB and Amber #MCL0040ABB. The lens looks to be the same design and the bases have the same mounting design…

view full answer...

Answer 5

Hi Fred; we carry the Dometic #DMC74FR which is the 6 gallon version but for whatever reason we have never had their 10 gallon water heater WH-10GE. You can stick with the Dometic if you want but I'm sorry to say you will have to pick it up…

view full answer...

Answer 6

Hey Tom, that does sound like you have a bad board on your GC10A-4E. Atwood is no longer around so unless you can find replacement parts somewhere the only option would be to completely replace the water heater. You can swap it out for a similar 10…

view full answer...

Answer 7

I attached a picture I got from Furrion that shows a wiring diagram for the #FACC12SA-BL as well as an install video for you to check out.

view full answer...

Answer 8

Please see the attached images for wiring diagram and installation instructions for the Furrion Chill Replacement RV Air Conditioner for Furrion Setup, #FR86PR.

view full answer...

Answer 9

The trigger wires of the Voyager Multi Camera Controller for Observation Monitor #CSW3 that you referenced are going to be the circuits you want to activate the cameras. So for example if you had a side camera that you wanted to come on when you…

view full answer...

Answer 10

All of the fans and fan motors that we offer are replacement items for roof vents that came with fans. If the roof vent in your trailer did not come with a fan, then you may be able to add a fan, but you will likely have to fabricate a mount for the…

view full answer...

Answer 11

The factory backup camera prep packages usually consist of a pre-installed bracket with connector. Therefore, all you should have to do is remove the cover and mount the new camera to the bracket and plug in the connector. That said, the Furrion…

view full answer...

Where is the On Off Switch on the 701 LED Solar Motion Light

Product Page this Question was Asked From

Continue Researching