bing tracking image
Q & A Icon

No Dot Displayed without Trailer Connected with a Draw Tite Brake Controller part # 5504  

Updated 05/27/2014 | Published 05/24/2014

Question:

With trailer disconnected I have a red dot on display when brake pedal is pressed but not when the manual lever is used.

1

Helpful Expert Reply:

Just got off the phone with my contact at Draw-Tite, he tested their Activator IV and found that the dot will show up without a trailer connected and the manual override activated. He said the problem could be that your manual override lever is bad (maybe try sliding it a few times to clean the contacts). The other possibility is that the ground circuit of the controller isn't making a good contact. I would check the condition of the ground wire and make sure it's connected to a clean metal surface.

I attached installation instructions and an FAQ article on troubleshooting brake controller installs for you to check out.

expert reply by:
1
Jameson C

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>