Height of Timbren Rear Suspension Enhancement System GMRC20
Updated 01/05/2026 | Published 09/14/2024
Question:
What are the dimensions of the TRGMRC20 steel cup and rubber cylinder?
asked by: Bob D
0
Expert Reply:
Hey Bob,
The bracket that comes with the Timbren Rear Suspension Enhancement System # TGMRC20 is 1-7/8" tall while the rubber spring is 4-3/4" tall. I don't have any more detailed dimensions than that, but if you can let me know what vehicle you're looking to install this kit on I can let you know if they will fit or if you need a different kit!
expert reply by:
Jon G
0
Product Page this Question was Asked From
Timbren Rear Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Standard Duty
- Rear Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Jacks for 1999 Lance 845 Truck Bed Camper
- Q&A: Can RV Propane Source be Regulated Twice and Still Function
- Q&A: 2005 Ford Excursion Squats when Using Husky Weight Distribution with 9,000 Pound Trailer
- Q&A: Recommended SumoSprings for a 2025 Nissan Frontier w/ a King Cab
- Q&A: Can I Use Timbrens In Conjunction With Fastway Weight Distribution System
- Q&A: Recommended Air Bags for a 2018 Nissan Titan and Cost of Install
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Determining Trailer Tongue Weight
- Q&A: Recommended Aftermarket Underbed Puck System for 2017 Chevy Silverado 2500 or 3500
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Article: Must-Have Flat Towing Components
Robin H.
1/5/2026
Hey Bob, did you get a chance to check if those dimensions for the Timbren suspension kit fit your vehicle? Once you know how it lines up, I can help confirm if that’s the right setup or if another kit would work better.