Mounting Hardware for LED RV Utility Light with Switch

Question

Question:

What mounting hardware do I need for this light? Do you have an item number or a link to a set?

asked by: Sriram S

0

Expert Reply:

Hello Sriram; the LED RV Utility Light with Switch # 328-K-0054BS uses #6 screws for installation.

expert reply by: Robin H

0

Robin H.

1/12/2026

Hey Sriram, did the #6 screws work well for mounting your LED RV Utility Light with Switch? Knowing how the fit turned out could help others setting up the same light.

Answer 1

The dimensions of the screws used largely depends on your individual camper and the base of the lights. I would recommend using stainless steel self-tapping screws so that they they have a firm grip and will withstand corrosion.

view full answer...

Answer 2

I reached out to my contact at Command and she said the LED RV Utility Light #328-K-0054B has a raw lumen output of 4,000, which makes for a really bright light for easy nighttime viewing. I have attached a short video review that you can check out…

view full answer...

Answer 3

The light output of the Command Porch Light part #328-007-60WE is 560 Lumens. It also only draws .21 of an amp! I attached a review video link for this for you to check out as well.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Mounting Hardware for LED RV Utility Light with Switch

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching