Recommended Ball Mount for a EcoHitch Mounted Behind the License Plate
Published 04/16/2024
Products Featured in This Question
Question:
I had the EcoHitch Invisi hitch installed on my 2015 Chevy Volt. Only problem is my old 2inch drawbars/ball mounts previously used with pickup hitches dont fit in the receiverthey go in, but not far enough to line up the holes. What drawbar do I need to fit that hitch?
asked by: Lyndon B
Expert Reply:
From the hitch pin hole to the edge of the license plate is 8" with the EcoHitch Invisi Trailer Hitch item # 306-X7186 installed on your 2015 Chevy Volt. With this in mind, I recommend the Draw-Tite Ball Mount for 2" Hitches item # 2753. It measures 9" from the hitch pin hole to where the hitch ball sits so this will give you plenty of room to clear your license plate and the back of your car.
For hitch balls you will want item # 63845 for a 2" ball or item # C40002 for a 1-7/8" ball.
Product Page this Question was Asked From
EcoHitch Invisi Trailer Hitch Receiver - Custom Fit - 2"
- Trailer Hitch
- For Towing
- Class II
- 300 lbs TW
- 2000 lbs GTW
- 2 Inch Hitch
- Completely Hidden
- EcoHitch
more information >
Continue Researching
- Q&A: Stealth or Hidden Hitch for 2015 Chevrolet Volt
- Q&A: Comparing The Curt # 56146KIT With The Curt # 59236 For 2017 Hyundai Santa Fe Sport
- Q&A: Is There a Trailer Wiring Harness Option for a 2013 Chevy Volt
- Q&A: Best Trailer Hitch for 2012 Chevy Volt
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Spare Tire Carrier Recommendation for Class C Motorhome
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Can You Carry Two 50 Lb Bikes on a 2012 Chevy Volt with Curt Trailer Hitch Receiver
- Q&A: Bolt Size of Receiver Tube Bolt of the EcoHitch # 306-X7180 on a 2012 Chevy Volt
- Article: Trailer Hitch Installation Tips
- Article: Trailer Wiring Diagrams