Solution for 1/2-20 Self-Tapping Bolts for Replacement I-Beam Jack Bracket
Updated 04/14/2024 | Published 04/12/2024
Question:
Where can I find the 1/2-20 self-tapping bolts needed for the replacement jack bracket I-Beam? I purchased your set of replacement beams and non-came with it and now Ive searched around on-line and Lowes/home depot and cant find any.
asked by: Juan P
0
Expert Reply:
That is a good question. At this time I am also unable to find any 1/2"-20 bolts that are self-tapping to install the # LC349975. My suggestion would be to drill and tap the holes separately and use regular 1/2"-20 bolts.
expert reply by:
Robin H
0
Product Page this Question was Asked From
Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Brackets
- Lippert
more information >
Continue Researching
- Q&A: Best Replacement For Older Dometic Duo Therm 57915.531 Ducted Single Zone AC System With Furnace
- Q&A: Availability Of Shorter Stabilizing Jack For Lippert Ground Control 3.0 Leveling System
- Q&A: Torque Spec For Grade 8 Bolts On Lippert 6-Point Leveling System
- Q&A: Replacement Air Conditioner for RV Duo Therm 57915.531
- Q&A: Determining The Correct Replacement Entry Lock For A 2008 Fleetwood Bounder 38V
- Q&A: Correct Breaker Size for Replacement 6-Point Controller for Lippert Components Ground Control 2.0
- Q&A: Recommended Electric Winch for Raising and Lowering a Pop Up Camper
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Best Landing Gear
- Article: Trailer Wiring Diagrams