Where Does Converter Box of Curt C79CR Mount on 2022 Subaru Legacy
Published 12/13/2023
Products Featured in This Question
Question:
Instructions for this wiring harness say to use a fish wire to feed drivers side tail light connecter from below the tail light, routing behing the bumper cover plastic trim, exiting below the exterior of the driver side frame. My question is... how are the wires for drivers side tail light routed from the control module which instructions indicate should be secured in rear of trunk/drivers side, to the drivers tail light connector located outside the trunk up high at the drivers side tail light area, as instructions indicate to do? I see no issue feeding wire to passenger side tail light as instructions detail. Please advise ASAP, Thank you!!
asked by: Joe G
Expert Reply:
The instructions for the Curt trailer wiring harness part # C97CR are a little unclear but basically the box does not get mounted inside the vehicle and instead mounts behind the bumper which you can see pointed out in step 7.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Visible
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Location Of Trailer Wiring Harness Connector On A 2023 Subaru Outback Wagon
- Q&A: Recommended Aftermarket Underbed Puck System for 2019 Chevy Silverado 3500
- Q&A: How Does The Curt C67JR Install On A 2020 Subaru Legacy Sport?
- Q&A: How Long Does EcoHitch for 2025 BMX iX Take to Install
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Q&A: Does Removal of Lower Air Shutter on 2023 Chevy Equinox For etrailer Base Plates Affect Warranty
- Q&A: No Signal And PWM Fix For Furrion Vision S Camera System Connected To 2022 GMC