Is Blinking Light on Trailer Breakaway Kit When Connected to Tow Vehicle a Problem
Published 12/04/2023
Question:
I just installed a hopkins breakaway switch on my 1995 Jayco designer series 5th wheel trailer. The switch works like its supposed to and engages the brakes when disconnected from the truck. When I connect the plug to the truck the trailer brakes work when I press the brake pedal like they a supposed to. Even though everything is working correctly the LED light on the hopkins breakaway switch flashes red when the trailer plug is connected to my truck. Since everything is working as intended does this blinking red light matter?
asked by: Ethan
Expert Reply:
I wouldn't worry about the blinking red light. It's probably an indicator that is showing that the battery is being charged. We get this question every now and again and there is no problem.
Product Page this Question was Asked From
Hopkins Pull to Test Breakaway Switch with 48" Long Cable
- Accessories and Parts
- Trailer Breakaway Kit
- Switches
- Hopkins
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Parts Needed to Flat Tow 2018 Ford F-150 With 4 Wheels Down
- Q&A: Parts Needed to Flat Tow 2019 Ford F-150
- Q&A: Recommendation for Trailer Brakes On a 16 Foot Enclosed Trailer with 2 Axles And 5,000 LB GVW
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Q&A: Delay in Electric Over Hydraulic Trailer Brakes with Dexter System
- Q&A: How to Initially Adjust the Dexter Nev-R-Adjust Electric Trailer Brakes
- Q&A: Replacement 12 Inch Brake Assemblies for Redline EB01-140 and EB01-145 From Dexter Axle
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Measure a Trailer Axle
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Testing Trailer Brake Magnets for Proper Function