Installing Hoop II Multi-Mount Step for 2012 Silverado Extended Cab
Updated 04/02/2014 | Published 04/01/2014
Question:
Do you have to drill holes in the truck to mount the step? What size and what type of attachment devices needed are they provided with step? thank you.
asked by: Robert W
0
Expert Reply:
You do have to drill 2 holes per step to mount the step. The mounting hardware (5/16” x 5/8” hex bolts, nuts and washers, 5/8” long sheet metal screws, wedge washers) is provided.
I have included a link to the installation instructions.
expert reply by:
Chris O
0
Product Page this Question was Asked From
Carr Custom-Fit Side Steps - Hoop II - Black Powder Coated Aluminum - 7" Step - 1 Pair
- Nerf Bars - Running Boards
- Side Steps
- 3-1/2 Inch Wide
- Matte Finish
- Fixed Step
- Aluminum
- Black
- Carr
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Removing Plugs that Cover Screw Holes of TecNiq Low Profile Stop Tail Turn Light
- Q&A: Does the Power Watchdog Surge Protectors Make any Noise?
- Q&A: Does Curt Base Plate 2021 Ford Ranger Work with Blue Ox Tow Bar
- Q&A: Why Would Peak Back Up Camera Turn Off When Brakes are Applied
- Q&A: Can PowerMax Converters Be Used Without 12V Battery In The Camper?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Mounting Hole Dimensions Of Carr Hoop Step # CARR103991
- Q&A: Recommended Cover for Northern Lights 10-2 EX CD SE Truck Camper
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: Gooseneck to 5th Wheel Adapters