Mounting Hole Dimensions of Draw Tite Hitch 75189
Published 10/04/2023
Question:
May I get the dimension measurements for this hitch? Specifically the center to center and anything else you can share. Thank you.
asked by: Doug
0
Expert Reply:
For the Draw Tite hitch part # 75189 the distance between the mounting holes from left to right is 40 inches. From the front holes to the next hole back is 3-3/4 inches, and from the middle hole to the rear most is 11-1/4 inches.
expert reply by:
Jameson C
0
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Do Draw Tite Hitches # 41930 and DT45515 Both Fit 2006 Chevy Suburban
- Q&A: What Air Pressure Should I Run in My Trailer Tires?
- Q&A: Towing Capacity of 2016 GMC Savana 2500 with 4.8 Liter
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Is Loctite Suggested When Installing Trailer Hitch Receiver
- Q&A: Will the GMC Hitch Part # C31016 Fit a 2000 GMC Savana Van with Leaf Springs in Front
- Q&A: Replacement Parts for B&W Companion Hitch # BWRVK3050
- Q&A: Is Socket Post of B and W Companion Fifth Wheel Hitch Adjustable
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: The Ultimate RV Camping Checklist for Your First Year RVing