Shouldn't Hopkins Square 6-Way 37995 Come with Thicker Gauge Wiring
Published 10/03/2023 >
Products Featured in This Question
Question:
Hi There, RE product Item # 37995 I believe the specs given are that the wires are 18 gauge. Shouldnt some of the wires be thicker than 18 gauge, maybe 14 gauge or even a 12 gauge. I believe the electric brakes need something thicker. Please let me know. Thank you,
asked by: Roman D
Expert Reply:
All of the wires of the Hopkins 6-pole part # 37995 are 18 gauge. I would agree with you though that the ground circuit, brake output, and 12 volt accessory circuit should be a heavier gauge like 12. That's part of why I don't recommend this as a great solution for trailer wiring.
Instead I would replace the square connector on the trailer with a standard 7-way like the part # A10-7W6 which comes with appropriately rated wiring for circuits.

Product Page this Question was Asked From
6-Pole Square Trailer Wiring Connector Kit (Car and Trailer Ends)
- Custom Fit Vehicle Wiring
- Wiring Extensions
- Universal Fit
- 6 Square
- Plug and Lead
- Hopkins
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: How to Make 6-Way Square to 7-Way Adapter
- Q&A: How to Make a 6-Way Square to 4-Way Flat Trailer Wiring Adapter
- Q&A: Comparing Curt, etrailer and Draw-Tite Trailer Hitch Receivers For a 2024 Ford Bronco Sport
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Fixed Side Vs. Float Side for Replacement Standard Dual Rack Repair Kit Wall Slide-Out
- Q&A: Recommended Plug And Play Replacement For A Dometic RV Rooftop Air Conditioner Unit
- Q&A: Recommended 7-Pin Wiring Harness for a 2023 Tesla Model 3
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Best Hitch Cargo Carriers
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Brake Controller Installation: Starting from Scratch