Will iGen4500DF Inverter Generator Fit on Stromberg Carlson Generator Bunk CC-255
Updated 09/27/2023 | Published 09/26/2023
Question:
I have a iGen4500DF Inverter Generator - Dual Fuel, I think it’s too big for the platform but I swore I saw a picture with it on it. Could you confirm either way? Thanks so muc
asked by: Matthew M
0
Expert Reply:
I looked up the dimensions of your iGEN4500DF generator and found them to be 24.5L x 17.5W x 20H in. Based on that it would fit on the Stromberg Carlson Generator Tray part # CC-255.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Stromberg Carlson Trailer Tray Cargo Carrier for A-Frame Trailers - 300 lbs
- RV Cargo Carrier
- Cargo Carrier
- A-Frame Mount
- 300 lbs
- Fixed
- 32 Inch Wide
- 20 Inch Deep
- Steel
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Will Soft Start Kit for Coleman-Mach RV Air Conditioners Fit a Coleman-Mach 2000?
- Q&A: Replacement Slam Latch Recommendation for Winnebago Minnie Winnie Travel Trailer
- Q&A: Replacement Propane Gas Detector for Atwood 31013
- Q&A: Looking to see how the Torklift PowerArmor locking Battery Box Mounted to a Trailer Tongue?
- Q&A: Testing a Vehicle Side 7-Way Trailer Connector for Proper Function
- Q&A: How to Carry a Generator on an A-Frame Travel Trailer
- Q&A: Which Support Struts Are Compatible With 28' Keystone Travel Trailer With Rear Bumper?
- Article: How to Measure for Trailer Hitch Drop
- Article: Carrying Bikes While Towing a Pop-Up Camper Trailer
- Article: How to Choose a Bike Rack for a Motor Home or RV
- Article: REDARC Tow-Pro Liberty vs Tow-Pro Elite
- Article: Converting Your RV Water Heater to Tankless
- Article: Determining Trailer Tongue Weight