Where To Get Replacement GFCI Outlets For A Go Power Industrial Pure Sine Wave Inverter
Published 08/09/2023
Question:
Kevin C, thank you for your quick response to our question on the 700 w Go Power inverter. We had already tried your suggestions. Upon reading the manual more closely, we found the three green lights were for the inverter. The slow flashing red light was for the GFCI, where it stated, if flashing then replace. This is no ordinary GFCI. It has a circuit board attached to the back. Where can we get a replacement GFCI? Or cant we? Thank you,
asked by: Kent K
Helpful Expert Reply:
I spoke with Go Power and they stated that the GCFI outlet in your Go Power Industrial Pure Sine Wave Inverter # 34279946 can be replaced with one from a local hardware store. Their tech stated that the circuit board can slide off by removing the screws and that it wouldn't be an issue.
Product Page this Question was Asked From
Go Power Industrial Pure Sine Wave Inverter - GFCI - 700 Watt - 12V
- Power Inverter
- Pure Sine Wave
- Electronics
- 12V
- 700 Watts
- Inverter Only
- AGM/Gel/Lead Acid
- Lithium
- Outlet
- RV
- Go Power
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Would 2 BattleBorn 100ah Lithium Batteries Be Enough For 1,800W Inverter In RV?
- Q&A: 2021 Winnebago Minnie 30A Pure Sine Wave Inverter For Laptop And Microwave When Off-Grid
- Q&A: Does the Go Power Remote Continue to Allow the Inverter to Draw Power After Turned Off
- Q&A: Fuse and Breaker Locations on Lippert Power Stabilizer Jack for Forest River Trailer
- Q&A: Replacement Circuit Breaker for Husky Brute Electric Trailer Jack HB4500
- Q&A: How To Install The Go Power Industrial Pure Sine Wave Inverter Charger
- Q&A: Will Dometic FreshJet 3 Air Distribution Panel work with Advent Air AC Unit
- Article: Trailer Wiring Diagrams