Do the Carr Custom Fit Steps Use Existing Mounting Locations or is Drilling Necessary to Install
Updated 03/10/2014 | Published 03/08/2014
Products Featured in This Question
Question:
do i need to drill and holes to mount these or do u use already existing holes
asked by: Tom
Expert Reply:
I have confirmed with my contacts at Carr, and the installation of th Carr Custom Fit Hoop II # CARR105772 will require drilling the correct installation holes on your truck. You will not be using existing mounting locations.
I also confirmed with my contact, and the # CARR105772 is confirmed as a fit for a 2014 Dodge Ram gas pick up. If your Ram is a diesel you will want to use the # CARR107442. According to Carr, this #CARR107442 is confirmed to work with both gas or diesel trucks.
I have linked the installation instructions for your reference.
Product Page this Question was Asked From
Carr Custom-Fit Side Steps - Hoop II - Polished Aluminum - 7" Step - 1 Pair
- Nerf Bars - Running Boards
- Side Steps
- 3-1/2 Inch Wide
- Polished Finish
- Fixed Step
- Aluminum
- Silver
- Carr
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Step Tube Recommendation for 1995 Ford F-250 wit Extended Cab
- Q&A: Differenced Between Carr CARR105772 and CARR109772 Hoop Steps
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Recommended 7 Inch Steps for a 2023 Ram Promaster 2500
- Q&A: Best Side Steps for Clearance and Stepping Area on a 2019 Mercedes-Benz Sprinter 2500
- Q&A: Replacement Brake Assembly for Axletek 44-GG
- Q&A: Does Carr Single Step CAR89MR Fit 2021 Ram ProMaster 2500
- Q&A: Are There Running boards That Do Not Require Drilling For 2019 Ram ProMaster Van 136" Wheelbase