TruXedo TruXport Tonneau Cover Compatibility With Truck Bed Toolbox
Updated 06/19/2023 | Published 06/16/2023
Question:
I have a tool box in the front of the bed. How far does the cover and clamps hang over inside the bed? I am trying to make sure that I have enough clearance for the cover of my tool box to open and not rub the clamps or the cover.
asked by: Bill K
Helpful Expert Reply:
The rails of the TruXedo TruXport Soft, Roll-Up Tonneau Cover # TX272801 are going to sit directly on top of the bedrails and keep the cover from dipping down below the bedrail line. The clamps would be the only thing sticking into the bed and would be approximately 1-1/4", but can moved to accommodate the toolbox.
Product Page this Question was Asked From
TruXedo TruXport Soft, Roll-Up Tonneau Cover
- Tonneau Cover
- Roll-Up - Soft
- Not Rack Compatible
- Opens at Tailgate
- Tailgate Lock
- Standard Profile - Top of Bed Rails
- Vinyl
- Vinyl Grain
- Truxedo
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Troubleshooting Signal Loss With A Furrion Vision S Camera System
- Q&A: Troubleshooting Lag And Frozen Screen With A Furrion Vision S RV Camera System
- Q&A: What is the Tallest 5th Wheel Hitch for the Ford Factory Puck System?
- Q&A: Air Bags for 2025 Chevrolet Silverado 2500 ZR2 With 7,500 lb Capacity and Wireless Air Compressor
- Q&A: Does EcoHitch or Curt 2024 Chevy Silverado 2500 Front Mount Receiver Sit Higher
- Q&A: 2023 GMC Sierra 2500 Crew Cab Westin HDX Nerf Bars
- Q&A: Recommended Roll Up Bed Cover For A 2022 Chevy Silverado 2500 With Multipro Tailgate
- Article: Thank you!
- Article: How to Choose the Best Tonneau Cover
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Tester Battery Replacement for Part Number 8010