Will The Better Bath RV Kitchen Sink # LC385313 Have Enough Overhang For A 26" x 15" Cutout

Question

Question:

My RV has a kitchen sink cutout measuring 26” x 15”. Will this sink have enough overhang to top mount in the cutout?

asked by: Richard B

0

Expert Reply:

The Better Bath RV Kitchen Sink # LC385313 has an inch of overhang on each side with an internal measurement of 13-7/8" long x 25" wide so it'll have enough overhang to properly fit your 26" x 15" cutout.

expert reply by: Kevin C

0

LC385313 Dimensions
(click to enlarge)

Answer 1

For a 25-3/4" x 14-3/4" cutout we have the following single bowl and double bowl options: Single Bowl: Better Bath RV Kitchen Sink #LC385313 Double Bowl: Better Bath RV Kitchen Sink #LC388412 Better Bath RV Kitchen Sink #LC385314 LaSalle…

view full answer...

Answer 2

The Better Bath Double Bowl RV Kitchen Sink Item #LC388412 depth measurement, front to back of the bowls, is 13-3/4 and has width of 24-3/4. If your opening is 25-3/4 x 14-3/4 then you will potentially have an inch of the top edge of the sink flange…

view full answer...

Answer 3

I suppose you could drill a hole into the Better Bath RV Kitchen Sink part #LC388412 to mount your faucet/tap but that is not really it's intended use as it is mainly used in under-mount applications. If you were to use this sink as a top-mount…

view full answer...

Answer 4

While the Better Bath Double Bowl RV Kitchen Sink #LC388412 was intended to be an undermount sink you certainly could install it as a drop-in.

view full answer...

Answer 5

We have the Better Bath RV Sink part #LC385313 which is 27 inch by 16 inch like you said you want and has a single bowl. This is an undermount and we do not carry any that mount over the counter.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 11

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Will The Better Bath RV Kitchen Sink # LC385313 Have Enough Overhang For A 26" x 15" Cutout

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching