Manual Pull Out Step Recommendation for a 1992 Bounder Motorhome on a P30 Chassis
Published 02/13/2014
Question:
MY POWER STEPS NO LONGER OPERATE. THE GEAR BOX IS SHOT. I WANT TO REPLACE WITH A MANUAL PULL OUT SET OF STEPS. WHICH MODEL WOULD YOU SUGGEST? THANK YOU
asked by: TOM M
Expert Reply:
After looking at some pictures of your 1992 Bounder built on a P30 chassis it would seem that step setup with 2 steps would be about ideal based on the height of your motorhome. With that being said I believe the RV Manual Pull Out Step # SMFP-2120 that you referenced would be an excellent choice.
I attached a measuring video that will show you how to measure to pick out the correct step system and an installation video that will show you how to install these steps.
Product Page this Question was Asked From
Flexco Manual Pull-Out Steps for RVs - Double - 8" Drop/Rise - 20" Wide - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 20 Inch Wide Step
- 23-5/8 Inch Wide
- 2 Steps
- 8 Inch Drop/Rise
- 19 Inch Entry
- 20 Inch Entry
- 21 Inch Entry
- 22 Inch Entry
- Steel
- Stromberg Carlson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will Pull Out Steps fit 2011 Palomino Puma 27KFQ
- Q&A: Mounting Hole Spacing on the Flexco Manual Pull-out Steps for RVs
- Q&A: Replacement A-Frame Jack for Lippert Ground Control TT
- Q&A: Flexco Double Step Width Dimensions
- Q&A: Double Step Replacement for 2017 R-Pod 180
- Q&A: Parts Needed To Install a 12 Volt Battery To an Off Road Trailer For Lighting
- Q&A: Can 2-Step Lippert Steps Replace a Single Step on a 2017 Winnie 170S
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 4-Step Guide to Installing RV Solar Power
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Calculating Portable Generator Power Needs
- Article: Trailer Wiring Diagrams
- Article: How Does an RV Water Pump Work?