Recommended 5,200 lbs Dexter Axle w/ a Bend
Updated 02/14/2023 | Published 02/09/2023
Products Featured in This Question
Question:
Looking for 94inch #5200 Dexter axle with the bend in axle to creates zero camber
asked by: Michael G
0
Expert Reply:
The Dexter 5,200 lbs axle we have item # 6340624 is 95" long so I recommend checking your measurements again. If it is in fact 94" you will need the Dexter Trailer Axle Beam item # 8327864. This is a 7,000 lbs axle but is 94" long. Both of these axles have the bend in the middle.
expert reply by:
Jerred H
0
Product Page this Question was Asked From
Dexter Trailer Axle Beam with 4" Drop E-Z Lube Spindles - 94" Long - 7,000 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Grade
- No Hubs
- 7000 lbs
- Spindles Only
- 78-1/4 Inch Spring Center
- 94 Inch Hub Face
- Drop - 4 Inch
- Dexter
more information >
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Are Bearings Already Installed On TruRyde Trailer Hub and Drum Assembly
- Q&A: What Type of Breakers Does Powermax Panel PM59VR
- Q&A: How Does Hot Air Vent From GE Appliances RV Washer/Condenser Dryer Combo
- Q&A: Will the CE Smith CE13511 replace a Titan 45264 Hub?
- Q&A: Solution for Needing Replacing Pump of Lippert Pump Assembly 646822
- Q&A: Can Magnetek 6345 Be Repaired Without Total Power Center Replacement
- Q&A: Do I Need Special Fuses Or Breakers When Installing New PowerMax Power Center Converter In RV?
- Article: Trailer Maintenance Schedule
- Article: Double-Eye Trailer Suspension System Review
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Frequently Asked Questions About Transmission Coolers
- Article: How to Replace an RV Roof Vent Cover