Can the Ends of Step Treads On Aries AeroTread Running Boards For a 2004 GMC Yukon Denali Be Glued?
Published 12/21/2022
Products Featured in This Question
Question:
I WOULD LIKE TO KNOW HOW THE STEP SKID IS ATTACHED TO THE ACTUAL RUNNING BOARD? MINE ARE BEGINNING TO RISE AT BOTH ENDS.
asked by: Timothy N
Expert Reply:
I reached out to Aries and they informed me the plastic step for the AeroTread Running Boards on your 2004 GMC Yukon Denali AWD are held in place by slots in the track. While they said you should be able to glue it back down the ends will surely pop back up again over time. As long as your mounting brackets are in good condition you can replace the steps themselves. We have the Stainless Steel # AA2051876 or Black Stainless # AA2051976 which are the 76" steps your Yukon will call for.
Product Page this Question was Asked From
Aries AeroTread Running Boards - 5" Wide - Aluminum - Polished Stainless Steel Trim - 76"
- Nerf Bars - Running Boards
- Running Boards
- 5 Inch Wide
- Cab Length
- Polished Finish
- Fixed Step
- Aluminum
- Silver
- Aries Automotive
more information >
Continue Researching
- Q&A: Replacement Hardware Kit for Thule TracRac TracVan Roof Rack
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Replacement Hub with Bearings LM67048 25580 and 2-1/4 inch Grease Seal
- Q&A: Looking For 1/2" x 20 Wheel Studs With .500" Knurl Diameter
- Q&A: Replacement 1/2" Thread Wheel Studs For A Trailer
- Q&A: Looking For Bearing Kit For 2017 EZ Loader Trailer With 5,200 lb Axles
- Q&A: Replacement Lug Nut Recommendation for Lugs Stamped G 1/2 RH/T