Can You Take The Plug Off Of A Kat's Heaters Vehicle Interior Heater
Updated 11/14/2022 | Published 11/12/2022
Products Featured in This Question
Question:
Can you take the plug off of the cord to run it through firewall
asked by: Mark M
Expert Reply:
The plug on the Kat's Heaters Vehicle Interior Heater # KH37100 is molded to the wiring so you wouldn't likely be able to get the plug back together once you were done. Instead you could cut the wires further back from the plug and trim back the casing and heat shrink butt connector # DW05744-10 the wires back together once you're through the fire wall. You will want to ensure that the wires are oriented in the same way when you reconnect them so I would mark one wire on both ends to ensure they go back together.
Product Page this Question was Asked From
Kat's Heaters Vehicle Interior Heater - 900 Watt - 120V AC
- Vehicle Heaters
- Interior Vehicle Heater
- 120 Volts
- 900 Watts
- Kats Heaters
more information >
Continue Researching
- Q&A: Are There Left and Right Hand Entry Door Locks
- Q&A: Difference Between 150W and 300W Settings on Kat's Heaters Ceramic Interior Heater KH37500
- Q&A: Does B&W Offset Gooseneck Coupler Reduce Towing Capacity of 2018 Ram 2500
- Q&A: Kats Vehicle Interior Heater Recommendation for Inside of John Deere Tractor
- Q&A: Mounting Kat's Heaters Vehicle Interior Heater
- Q&A: Recommended Hitch Extender w/a 7,500 lbs Capacity
- Q&A: What is Towing Capacity of 2020 Ram 2500
- Article: How to Measure for Trailer Hitch Drop
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?