Air Helper Springs For A 1999 Toyota Tacoma Extended Cab Pre-Runner
Published 10/12/2022
Products Featured in This Question
Question:
Looking at this product on your website, it shows it does and does not work for a 1999 Toyota Tacoma Extended Cab Pre-Runner with the 3.4 V6. Just want to confirm it will fit to order it. Does it need anything special because it is a Pre-Runner? Thank you for your help.
asked by: Eric R
Expert Reply:
Yes, The Air Lift Ride Control Air Helper Springs # AL59503 are confirmed to fit your 1999 Toyota Tacoma Extended Cab Pre-Runner. The site shows that it will fit both the Pre Runner and excluding the Pre Runner.
The air bags have a load leveling capacity up to 2,000 pounds and have an adjustable air pressure between 5 psi to 100 psi. It will let you manually adjust the air pressure to get the even load distribution and support that you will need.
The air bags will install between your vehicle's frame and its leaf springs. The Air Lift Load Controller II Compressor System for Air Helper Springs # AL25592 will allow you to monitor and automatically adjust your air spring pressure as needed to ensure safety and appropriate support. It will work with the air bags mentioned above.
I attached a review video link below.
Product Page this Question was Asked From
Air Lift Ride Control Air Helper Springs - Rear Axle
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Standard Duty
- Rear Axle Suspension Enhancement
- Air Lift
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Will PacBrake Air Bag Kit # PB54ZV Fit 1999 Toyota Tacoma 4x4
- Q&A: What's the Difference in Air Lift Kits for a 2001 Toyota Tacoma?
- Q&A: How Do I Measure the Drop Distance on a Trailer Drop Axle?
- Q&A: What is Purpose of Lip on Mounting Bracket of Firestone Ride Rite Kit F2558
- Q&A: How to Measure To Determine Correct Firestone Lift Spacers for Ride-Rite Kit on 2018 Nissan Frontier
- Q&A: Camper Tie-Downs For a 2016 Nissan Frontier Crew Cab With Factory Receiver
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Q&A: 10k Dexter Replacement Hub for a 8-415