Determining The Correct Replacement Ceiling Lights For A 2014 Fleetwood Southwind Motorhome
Updated 09/12/2022 | Published 09/10/2022
Question:
Ceiling lights for a 2014 Fleetwood Southwind
asked by: Richard B
Expert Reply:
To replace the lights in your 2014 Fleetwood Southwind Motorhome you'll need to first remove one of your current lights and measure the cutout hole. This will allow you to pick a similar fitting light so that you don't have to enlarge the hole or worry about the light being smaller than the hole.
For example, the Glantastic LED RV Puck Light # 328-K-58L34P9 you were looking at requires a 3-1/4" diameter cutout hole. If you can tell me what your cutout hole size is then I can help find the correct fit for your application.
Product Page this Question was Asked From
Glantastic 12V RV LED Puck Light - Recessed - 4-1/4" Diameter - Warm White
- RV Interior Lights
- Puck Light
- Warm White
- No Switch
- Recessed Mount
- LED Light
- 12V
- White
- Command Electronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Warm White 4-1/4" Diameter Puck Light
- Q&A: Replacement Options For Two Dometic Duo-Therm AC Units # 630516.331
- Q&A: Can I Put Four 6 Volt Batteries in the Buyers Products Trailer Tongue Toolbox 3371701385?
- Q&A: Recommended D-Ring Adapters for Flat Towing a 2024 Ford Bronco Raptor
- Q&A: Part Needed to Connect Roadmaster Tow Bar to 2023 Ford Bronco Badland
- Q&A: Trailer Hitch and Wiring Recommendation for 2015 Ford Escape
- Q&A: Inverter for Use with Go Power 200 Watt Solar Panel Kit 34282181
- Article: Trailer Wiring Diagrams
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Hitch Adapters and Extenders
- Article: No Missteps Here: Best Camper and RV Steps (2022)
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: How to Measure Your Trailer Wheel Bolt Pattern