Troubleshooting Pitch Arm Not Staying Put on Solera Smart Arm 12V Power RV Awning

Question

Question:

After pulling down the arm to adjust pitch it goes back to its original position. What are we doing wrong?

asked by: Stephen P

0

Expert Reply:

If the pitch adjustment isn't staying in place for your Solera Smart Arm 12V Power RV Awning # LC517505 then you'll need to adjust the bolt (B) in the center of the joint to tighten up this function. Attached is a photo showing the location of the bolt.

expert reply by: Jon G

0

Adjustment Bolt (B) Location on Solera Smart Arm Awning
(click to enlarge)

Hob

3/24/2024

i have done that adjustment as tight as i can put 250 pounds behind. What would be the next solution. Thanks HOB

Reply

Jon G.

3/28/2024

@Hob Just to double check, are you using a 1/2" wrench to tighten the nut while also using a 1/4" hex wrench to hold the pitch arm?

Reply

Cperry

8/29/2024

I can’t believe the response to Hob! Hey Jon, here is your sign!

Reply

Answer 1

According to my research the correct replacement bearings are parts #25580 and #LM67048 with the replacement seal being part #GS-2250DL. These are available in the Bearing Kit #BK3-300. Just make sure that you have these bearings and that your seal…

view full answer...

Answer 2

You can check the condition of your hub's races by carefully removing all bearing grease with a rag to expose the actual surface of the races. When they are completely free of grease, etc., inspect them for any signs of scoring (very slight…

view full answer...

Answer 3

Bearing Kit #BK3-100 consists of bearings 15123 and 25580, matching races, grease seal and cotter pin. This kit is intended for a 6K axle. The same component parts are found in Lippert bearing kit 333950, also rated for a 6K axle. Two helpful…

view full answer...

Answer 4

Yes, it is black. The black fade awning on the Solera Smart Arm item #LC517517 is black on RV side and turns white as it goes towards the roller tube. Once it is all rolled up though you'll see the black fabric. I get you don't want black but…

view full answer...

Answer 5

Brien, it sounds like you did your research so kudos to you, but the awning you're looking at is not going to work with the wind sensor. You'd need to use the Solera Smart Arm 12V Power RV Awning #LC517517 instead. You're also going to…

view full answer...

Answer 6

The best way to ensure proper identification of the correct parts for your broken awning arm is to first find the identification tag on your arms. Often times this tag is located inside the arm itself so the awning must be extended to see it. Also…

view full answer...

Answer 7

When installing an awning like the Solera Smart Arm 12V Power RV Awning #LC517486, the arms will be secured to the wall framing. When the awning extends there will be quite a bit of leverage, so it is important to mount the awning to an area where…

view full answer...

Answer 8

Hey Mark, thanks for reaching out! Attached are 2 photos that Furrion provides in their instructions for the wiring of the Furrion Chill HE RV Air Conditioner System - Mutli Zone #FR67FJ. I believe the wire you're referring to is the…

view full answer...

Answer 9

I did contact Lippert Components on your behalf to look into this. There really is not a material difference between the two other than the 69-inch arm #LC759517 will have a slightly flatter projection than the 63 inch Arm #LC759516. That said, the…

view full answer...

Answer 10

The black fade awning on the Solera Smart Arm 12V Power RV Awning - 20' Wide - Programmable - Black Fade Item #LC517517 is black on RV side and turns white as it goes towards the roller tube. Because of this the white will roll up inside of the…

view full answer...

Answer 11

Hi Rick, LaSalle Bristol's roof membrane is made of PVC which is known to be durable and offer better protection against punctures and overall weathering. Alpha Systems offers TPO roof membranes that are more environmentally friendly/recyclable…

view full answer...

Answer 12

Hi Al, The 36841 Adco cover was actually made unavailable by the manufacturer so it is not something that can be purchased. That said, we do have a very similar cover for travel trailers between 20 and 22 feet, which is our RV Cover for Travel…

view full answer...

Troubleshooting Pitch Arm Not Staying Put on Solera Smart Arm 12V Power RV Awning

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching