Where Are The Wires For Pop & Lock # PL8540 Located In A Two Door 2015 Toyota Tacoma
Updated 08/08/2022 | Published 07/31/2022
Question:
I have routed the wires as indicated up the drivers side grommet. However Neither cluster of wires under the floor panel contain blue with red stripe or blue with black stripe as shown but the video is a 4 door model. There are numerous blues, lots of blue and white but no other options. Should I be looking elsewhere for the proper wires?? Thank you.
asked by: Brett
Expert Reply:
Yes, you will need to look elsewhere in your truck. The wiring you need to access to install the Pop & Lock Custom Tailgate Lock with Handle - Power Lock and Manual BOLT Lock - Black, part # PAL8540, in a two door 2015 Toyota Tacoma are behind the kick panels in the cab of your truck. The cover will be next to your ankles in the foot well.
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Pop & Lock Custom Tailgate Lock with Handle - Power Lock and Manual BOLT Lock - Black
- Tailgate Locks
- Tailgate Handle
- Power and Manual Lock
- Keyed Alike
- Vehicle Specific
- Black
- Pop and Lock
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Tailgate Lock For 1989 Ford F-250
- Q&A: How To Wire A 12V DC Tankless Water Heater In An RV That Previously Had A 120V Water Heater
- Q&A: Recommended Thule Rail Kit for Leer Fiberglass Truck Bed Topper
- Article: Rooftop Cargo Carriers
- Q&A: Recommended Shackle Kit for a Triple Axle Trailer w/ 2.4" Shackle Links
- Q&A: Is the Actuator Sold Separately for the Pop & Lock Power Lock Conversion Kit?
- Q&A: Recommended Replacement for Load Lock Truck Cap Lock
- Q&A: Battery Vent Tube Preventing Curt C11448 Hitch Install on 2021 Audi A5 Sportback Hybrid
- Article: Roof Rack Information