Will Curt Hitch Fit with 2011 Mitsubishi Endeavor LS
Updated 07/21/2022 | Published 07/20/2022
Question:
Im looking at a hitch for my 2011 Mittsubishi Endevor LS I think I need a Curt 13113 can you verify this for me. My muffler should have to be dropped to mount properly.
asked by: Chris S
Helpful Expert Reply:
Yes, the Curt Trailer Hitch Receiver # 13113 is what you need for your 2011 Mitsubishi Endeavor LS. You might have to temporarily lower the muffler by removing the rear rubber hange, but we've found this to vary from vehicle to vehicle. I'm attaching a helpful article on moving a vehicle exhaust around to fit with a trailer hitch if you'd like to check it out.
Attached is an installation video for you to check out. If you let me know what you're planning on using the hitch for I'd be more than happy to make a recommendation for you!
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Tekonsha Brake Controller Wiring Adapter For A 2025 Ram 1500
- Q&A: Inner and Outer Diameter of the Chrome Edge Trim SAT012ET
- Q&A: Trailer Wiring Harness for 2004 Mitsubishi Endeavor
- Q&A: Where Does the 4-Flat Connector from Wiring Harness # C56039 go on a 2010 Mitsubishi Endeavor
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Difference Between Underslung and Overslung Coupler For Weight Distribution System
- Q&A: Does the Tekonsha P3 Trailer Brake Controller Turn Off or Stay On All the Time