Removing Cap from Wiring Harness Behind Battery of 2012 Outlander to Install # 118518 Trailer Wiring
Updated 10/24/2013 | Published 10/22/2013
Question:
how to remove the plug off the wiring behind the head light to attach the new wire with the fuse to the battery
asked by: R S
1
Helpful Expert Reply:
To remove the protective cap on the wiring connector, there is a release button on the side of the connector. Push and hold the button while pulling off the cap. You might need to use a set of locking pliers to get enough grip on the cap, but make sure not to damage the connector itself.
You can see the button I am speaking of in the photo I have edited for you.
expert reply by:
Mike L
1
click to enlarge
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Wiring Harness for a 2011 Mitsubishi Outlander
- Q&A: Replacement Disc Brake Caliper for a Tie Down Engineering 46304 Caliper