Fifth Wheel Wiring Harness for 2008 Toyota Tundra
Updated 09/28/2009 | Published 09/27/2009
Question:
Hi I am new to the 5th wheel pulling could you please help me with some parts? I was giving a reese 14k 5th wheel hitch and need the mounting kit to mount this to my 2008 Toyota tundra double cab long bed truck. I would like to know if the wiring kit # HM43397 is the right kit for me. If you could please help me I would like to order these and some other things also. THANK YOU FOR THE HELP
asked by: Mike
Expert Reply:
The Hopkins Fifth Wheel Hitch Install Kit, part # HM43397 will work just fine with your 2008 Toyota Tundra and your Reese Fifth Wheel.
This harness is long enough to reach into the bed, but not so long where you would have a lot of excess to bundle. Plus, if the female connector that bolts to the bed were to break it can be replaced.
Product Page this Question was Asked From
Hopkins Endurance 5th Wheel/Gooseneck 90-Degree Wiring Harness with 7-Pole Plug
- Custom Fit Vehicle Wiring
- 5th Wheel and Gooseneck Wiring
- Vehicle End Connector
- No Tow Package
- 7 Blade
- Plug and Lead
- Plug-In
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Does Landing Gear Leg LC179013 Attach Directly to Motor
- Q&A: Need Replacement Axle for LCI 4400 LB axle that says 95.5/75
- Q&A: Replacement Refrigerator Recommendation for a Norcold Model N 300
- Q&A: Correct Way to Wire Trailer Breakaway Kit
- Q&A: Tie Down LP7000 Brake Actuator Replacement
- Q&A: Recommended Leaf Spring Enhancement For A 2019 Ford F-450 Cab & Chassis
- Q&A: Installing a Brake Controller on a 2003 Ford F-150 Without a Factory Trailer Connector
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)