Plug In Play Wire Harness Vehicle End Location For 2004 Chevrolet ZR2 Tracker
Published 03/12/2022 >
Question:
where is this plug located ? Its not in jack compartment. And its not in with either tail light.
asked by: Dale
Helpful Expert Reply:
Great question.
This happens sometimes depending on what factory the vehicle was made in.
You are not far off from the plug. You need to go one panel closer to the front of the tracker.
You will need a screwdriver and a trim removal tool. You will find the connection point either zip-tied to another harness or just taped to the inner wall.
You can then plug in the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C55372 and route it going back to the jack compartment and then replace the panel making sure not to pinch the wires.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How To Properly Measure Slipper Springs For Your Trailer's Leaf Sping Suspension
- Q&A: Where is the Trailer Wiring Install Port for a 2003 Suzuki Vitara
- Q&A: Install of Curt Trailer Wiring Install Harness on 2001 Suzuki Vitara that Had Previous Wiring Kit
- Q&A: Class III Curt vs DrawTite Recommendation for 2003 Suzuki XL7
- Q&A: SumoSprings Suspension Enhancement for 2015 Fleetwood Bounder 35K Built on Ford F-53 Chassis
- Q&A: Troubleshooting Blue Ox Alpha Arms Not Both Fully Engaging
- Article: We Used 34 RV Tow Bars, and These are the Best for Flat Towing
- Q&A: Parts Needed To Add A Brake Controller To A 2022 Jeep Wrangler Unlimited
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)

