How Would You Install the Tow-Rax Floor Jack Mount to a Pickup Trailer
Updated 01/31/2022 | Published 01/30/2022
Question:
How can Tow-Rax Floor Jack Mount - Aluminum be mounted in a pickup trailer?
asked by: Chris W
0
Expert Reply:
To mount the Tow-Rax Floor Jack Mount # TWSPJSTAL to your pickup trailer you will find a spot that is as flat as possible. You will then drill through the Jack Mount and the floor of the pick up trailer and bolt/screw the Jack Mount to the floor of the trailer. I have included a video that talks about this. In the video they just used some self tapping screws, but you can drill larger holes and use bolts if you'd prefer.
expert reply by:
Scott S
0
Product Page this Question was Asked From
Tow-Rax Floor Jack Mount - Aluminum
- Trailer Cargo Organizers
- Tool Rack
- Floor Jack Bracket
- Contracting
- Landscaping
- Recreation
- Floor Mount
- Bolt-On
- Tow-Rax
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How Long Should it Take to Replace Electric Brakes and Bearings on a 6K Dexter Axle
- Q&A: Recommended Shank for a BulletProof Hitches Weight Distribution System
- Q&A: Recommended Cover for B&W Companion Slider 5th Wheel Hitch
- Q&A: Does The Kenda Karrier KR53 ST205/75R15 Radial Trailer Tire Come Balanced?
- Q&A: Troubleshooting Hydraulic Drum Brakes on Boat Trailer Rubbing After Removing Actuator
- Q&A: Comparing MORryde CRE3000 and SRE4000 Suspension Enhancement Kits for Trailer
- Q&A: Bearing Buddy to Replace Tie Downs Turbo Lube Oil Bath 48394 Cap?
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Wiring Diagrams
- Article: How to Wire an Electric Winch
- Article: The 5 Best Trailer Drop Hitches You Can Buy