How To Add In-Bed 7-Way to 2008 Toyota Tundra For 5th Wheel/Gooseneck Towing
Published 10/28/2021
Question:
I have a gooseneck trailer and would like to put a plug for the seven pin inside the bed of the truck is there a t connector that could be put in at the factory plug on the back bumper so I could run wiring into the bed for the 7 pin plug to eliminate possibilities of wiring harness being caught and pulled out
asked by: Wade B
Expert Reply:
It sounds like you are simply looking for an in-bed gooseneck/fifth wheel trailer wiring harness for a 2008 Toyota Tundra and if that is the case we have a great option for you in the Hopkins Endurance 5th Wheel/Gooseneck 90-Degree Wiring Harness part # HM43397. This harness will plug into factory ports under the truck so you don't have to do any splicing and you can still retain the 7-way at the bumper.
Product Page this Question was Asked From
Hopkins Endurance 5th Wheel/Gooseneck 90-Degree Wiring Harness with 7-Pole Plug
- Custom Fit Vehicle Wiring
- 5th Wheel and Gooseneck Wiring
- Vehicle End Connector
- No Tow Package
- 7 Blade
- Plug and Lead
- Plug-In
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Does Landing Gear Leg LC179013 Attach Directly to Motor
- Q&A: Need Replacement Axle for LCI 4400 LB axle that says 95.5/75
- Q&A: Replacement Refrigerator Recommendation for a Norcold Model N 300
- Q&A: Correct Way to Wire Trailer Breakaway Kit
- Q&A: Tie Down LP7000 Brake Actuator Replacement
- Q&A: Recommended Leaf Spring Enhancement For A 2019 Ford F-450 Cab & Chassis
- Q&A: Installing a Brake Controller on a 2003 Ford F-150 Without a Factory Trailer Connector
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)