Do I Need To Lower My Muffler To Install This Hitch?
Published 09/21/2021
Products Featured in This Question
Question:
I have a 2008 Mitsubishi Endeavor I want to put a hitch on it but my muffler is directly or almost directly blocking one of the hose for the hitch do I reroute my exhaust or do you make a hitch that goes around it what to do
asked by: Sara F
Expert Reply:
Hello, We have the Curt Trailer Hitch Receiver # 13113. It requires no drilling but you will need to temporarily lower the exhaust to properly and completely install the hitch. This Curt hitch is also rated for use with a weight distribution system.
If this will be for towing a trailer you will need a wiring harness like the Curt T-Connector Vehicle Wiring Harness # C56039. This will power the trailers lights and keep you safe and legal. And a Curt Towing Starter Kit for 2" Hitches - 2" Ball - 2" Rise, 4" Drop - 7.5K # C45554 to connect you to your trailer.
I will link videos below.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Tekonsha Brake Controller Wiring Adapter For A 2025 Ram 1500
- Q&A: Inner and Outer Diameter of the Chrome Edge Trim SAT012ET
- Q&A: Trailer Wiring Harness for 2004 Mitsubishi Endeavor
- Q&A: Where Does the 4-Flat Connector from Wiring Harness # C56039 go on a 2010 Mitsubishi Endeavor
- Q&A: What is the Difference Between a Class II and a Class III Hitch?