What Replacement Bolts Do I Need for My Thule 460R Feet?

Question

Question:

I have 460R and I lost the two screws that are 1” 1/4” that ties the mount. Uses Allan wrench to tighten. What is the part number for this item?

asked by: Nicholas C

0

Expert Reply:

The part number of the mounting screws that comes with the Thule Rapid Podium Feet for Thule Crossbars - Fixed Point # TH460R is the Replacement M6 x 16 mm Bolt # 919061654. Note that this part only comes with a quantity of 1 bolt. I went ahead and included a parts diagram from the instructional manual of all the parts included in # TH460R.

expert reply by: Bob C

0

Thule Rapid Podium Feet for Thule Crossbars - Fixed Point # TH460R Part List
(click to enlarge)

Answer 1

The Replacement Square Head Bolt #853-2089 that comes is the Thule Xadapt8 AeroBlade and Xsporter Load Bar Adapter #Xadapt8 is the longest M6 square head bolt we carry. This bolt is 61mm long and has threads that measure 1-1/4" long.

view full answer...

Answer 2

The screws for the #TH460R are m6x16 which we offer as part #919061654 but we do not have replacement screws for any of the fit kits as Thule does not offer that as replacement parts.

view full answer...

Answer 3

Just the portion of the foot part #7523036002B is not available separately. You'd have to replace the entire foot with this part number.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

What Replacement Bolts Do I Need for My Thule 460R Feet?

Products Featured in This Question

Continue Researching