What Would Explain Brake Controller Error Message Only in Morning
Published 09/13/2021 >
Question:
My draw tite brake controller blinks error in the morning start driving and it goes away
asked by: Randall P
Expert Reply:
In the morning there is a good chance that there is dew on the pins of the trailer wiring connectors which is causing a short or error message and once it dried up the error goes away. I would try cleaning the pins with sandpaper as that would cut down on chance of a short being created that would make this worse. Putting dielectric grease on the pins with the # 11755 would be a great idea as well as it helps prevent moisture from getting in.
Product Page this Question was Asked From
Draw-Tite Activator IV Trailer Brake Controller - Up to 4 Axles - Time Delayed
- Trailer Brake Controller
- Time Delayed Controller
- Electric
- Plug-In
- Under-Dash Box
- Under-Dash
- Up to 4 Axles
- LED Display
- Single Trailer Only
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Trailer Hitch and Wiring Harness for a 2025 Kia Sorrento Hybrid
- Q&A: Will Kodiak Trailer Hub for 3,500-lb Axles Fit Dexter 80043A Spindle On Boat Trailer
- Q&A: Help Picking Out Replacement Axle for 2004 Ranger Trail Trailer
- Q&A: Replacement Hub and Drum Assemblies for AL/KO 8460 Hubs and Drums
- Q&A: Replacing Wheels on a Trailer with 5 Spoke Utility Hubs and 8-14.5 Size Tires
- Q&A: Can 2020 Kia Soul-GT Turbo DCT be Flat Towed behind Motorhome
- Q&A: Difference Between Tekonsha 119251 and 119250 ZCI Wiring Harness for Mini Cooper
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Troubleshooting Brake Controller Installations
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Double-Eye Trailer Suspension System Review
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Wiring Diagrams

