Diagram Of Mounting Holes For Redarc Smart Start Battery Isolator 331-SBI12D
Updated 09/07/2021 | Published 08/31/2021
Question:
I need a diagram of the mounting holes for the SBI12D. I am replacing a Cole-Hersey 48525 and want to see if I can use the same mounting holes or at least the same mounting block in my Class C RV.
asked by: Bill F
0
Expert Reply:
As you can see in the attached photo, the Redarc Smart Start Battery Isolator - Dual Sensing - 12 Volt - 100 Amp # 331-SBI12D has bolt holes that are 2-1/8" from each other.
expert reply by:
Andrew N
0
Redarc Battery Isolator Bolt Holes
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Redarc Smart Start Battery Isolator - Dual Sensing - 12 Volt - 100 Amp
- Battery Charger
- Battery Isolators
- 12V
- Maintains Only
- Vehicle Battery to Auxiliary Battery
- Redarc
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Battery Isolation Manager for Precision Circuit BIM 160
- Q&A: Does Speed Affect Tire Wear on a Trailer Tire
- Q&A: Potential Causes for Uneven Wear on Trailer Tires
- Q&A: RV Trailer Battery Charging With 2019 Ford F-350
- Q&A: Is There MCD Innovations RV Shade Repair Kit that Comes with Motor Motor 50.336
- Q&A: Parts Needed to Flat Tow 2015 Jeep Cherokee Trailhawk
- Q&A: Breakers that Can be Used with Progressive Dynamics 4000 Series Inteli-Power Converter
- Article: Trailer Wiring Diagrams