Tow Mirrors for 2004 Winnebago Rialta

Question

Question:

Will they fit on out 2004 Rialta?

asked by: Jim D

0

Expert Reply:

For your 2004 Winnebago Rialta we don't have any custom fit tow mirrors but I looked up the mirror housing design of the vehicle and our universal CIPA tow mirrors part # CM11980-2 would fit and work great since there's a gap between the top of the mirror and the housing.

expert reply by: Jameson C

0

Answer 1

Hey Marc! The +/-5% accuracy specification refers to the scale's measurement tolerance. On a 2,000-lb capacity scale, that works out to about +/-100 lbs. at full capacity. As you pointed out, if you were measuring a much lighter tongue weight,…

view full answer...

Answer 2

Hey Ray, while there certainly is a lot of appeal to the Andersen WD systems like the part #AN88VR what we have found is that if the tongue weight is more than a few hundred lbs they just don't work as well as the traditional systems that use…

view full answer...

Answer 3

Although I have not heard of the CIPA Universal Fit Towing Mirror CIPA Universal Towing Mirrors part #CM11980-2 blowing off when attached properly I can say that the K-Source Universal Towing Mirrors part #KS3891-2 are a much more secure option. The…

view full answer...

Answer 4

Hey Simone! Your 2010 Toyota Tundra Platinum is going to to use the CIPA Custom Towing Mirror - Slip On - Driver Side #CM11301 and CIPA Custom Towing Mirror - Slip On - Passenger Side #CM11302 for towing mirrors. These mirrors will give you improved…

view full answer...

Answer 5

Hi Steve! There are two options that will help the sag you are getting in your 2021 Honda Pilot when you are towing. The first is the Coil SumoSprings Custom Helper Springs for Coil Spring Suspension #CSS-1125F. We have these listed as being for the…

view full answer...

Answer 6

Hi Bobby, All of the Benton products have a limited lifetime warranty, including the Benton MoveHitch part #B38VR. The warranty covers defects in materials and workmanship under normal use for the original owner. What are you planning on carrying…

view full answer...

Answer 7

Hey there Layla! There are a few different forms of weight distribution hitches, but the majority of the systems that have sway control use friction bars, which work similar to brake pads on your vehicle. This works really well, but it can sometimes…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Tow Mirrors for 2004 Winnebago Rialta

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching