Does Replacement I-Beam Jack Bracket LC349975 Use Self-Tapping Bolts
Updated 08/11/2021 | Published 08/10/2021
Question:
the rear jacks on this unit are set back almost 3 feet behind the wheels. Has been a problem from time to time with ground clearance. I need to relocate the jacks closer to the wheels. The bolt-on bracket looks perfect. Are self-tapping bolts used for mounting.
asked by: William W
0
Expert Reply:
Yes it does, what you will need are 1/2"-20 self-tapping bolts in order to install the bracket you asked about:
- Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 # LC349975
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Brackets
- Lippert
more information >
Continue Researching
- Q&A: Best Replacement For Older Dometic Duo Therm 57915.531 Ducted Single Zone AC System With Furnace
- Q&A: Availability Of Shorter Stabilizing Jack For Lippert Ground Control 3.0 Leveling System
- Q&A: Torque Spec For Grade 8 Bolts On Lippert 6-Point Leveling System
- Q&A: Replacement Air Conditioner for RV Duo Therm 57915.531
- Q&A: Determining The Correct Replacement Entry Lock For A 2008 Fleetwood Bounder 38V
- Q&A: Correct Breaker Size for Replacement 6-Point Controller for Lippert Components Ground Control 2.0
- Q&A: Recommended Electric Winch for Raising and Lowering a Pop Up Camper
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Best Landing Gear
- Article: Trailer Wiring Diagrams