Mini Momentary Switch for Use with RV Water Pump

Question

Question:

Have a 1999 Pace Arrow Vision 36B motorhome. The Ventline over the range hood has a control panel with multiple mini rocker switches to check black and grey tank levels, water level, battery levels, water heater and water pump. The water pump switch is apparently a momentary on that returns to center after being pressed up. The switch came apart during use. I replaced it with a normal on/off switch but it is inconvenient to have to depress switch 2x to turn on and again 2x to turn off. The switch has 2 connection prongs on the back side. It looks and sounds like this switch will perform original function. Your thoughts?

asked by: Dennis E

1

Helpful Expert Reply:

Yes the Mini-Momentary Switch part # 37212815 would be exactly what you are looking for. It is normally in off position but if you press it the momentary switch will activate circuit and then deactivate when you remove pressure on it.

expert reply by: Jameson C

1

Dan

11/12/2024

I need a hot water switch for my vent line panel. It is for Atwood water heaterG6A6E in a 1991 southwood.

Jameson C.

11/12/2024

@Dan I wish we could help but we aren't able to get Atwood water heater switches at this time.

Answer 1

Hello Todd. The Mini-Momentary 12V Switch #37212815 is made to fit a 3/4" x 1/2" cutout. It also has two connectors on the back so it sounds like this will meet all of your parameters.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 12

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Mini Momentary Switch for Use with RV Water Pump

Product Page this Question was Asked From

Continue Researching