Can Breakers be Used Instead of Fuses with Redarc Smart Start Battery Isolator
Published 06/03/2021
Question:
I see there is a recommendation for midi fuses on both ends in the diagram. Can I use a 100 amp heavy duty thermal circuit breaker on each end instead? Thanks
asked by: Josh
0
Expert Reply:
Yes, if you wanted to use 100 amp circuit breakers with the # 331-SBI12D instead of the fuses you certainly could.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Redarc Smart Start Battery Isolator - Dual Sensing - 12 Volt - 100 Amp
- Battery Charger
- Battery Isolators
- 12V
- Maintains Only
- Vehicle Battery to Auxiliary Battery
- Redarc
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is There MCD Innovations RV Shade Repair Kit that Comes with Motor Motor 50.336
- Q&A: Parts Needed to Flat Tow 2015 Jeep Cherokee Trailhawk
- Q&A: Charging Lithium Trailer Batteries While Driving
- Q&A: How to Determine if Vehicle Has Smart Alternator for Using REDARC Battery Charger
- Q&A: Redarc Smart Start Battery Isolator Recommendation for 150 Amp/Hour Alternator
- Q&A: Can a Hub with Outer Bearing 15123 and LM67048 Both Fit Same Spindle
- Q&A: How To Install a Brake Controller in a 2011 Chevrolet Silverado
- Article: Trailer Wiring Diagrams