Dimensions of the CE Smith Tie-Down Bracket for Boat Trailers # CE26214G
Published 04/01/2013
Question:
Hi, What are the dimensions of this tie-down bracket? Also, the info states that the galvanizing creates a 3 to 5mm coating. This should be 3 to 5 mil, not mm! 3mm would be a bit over 1/8. Just worth noting. Thanks,
asked by: Dave
Helpful Expert Reply:
I went and pulled a CE Smith Tie-Down Bracket # CE26214G from our warehouse to measure the dimensions and found that the overall length is 4 inches, the width is 1-15/16 inches, the bigger hole is 7/8 of an inch and the smaller hole is 9/16 of an inch.
Check out the video I attached that shows me taking these measurements.
Product Page this Question was Asked From
CE Smith Tie-Down Bracket for Boat Trailers - Galvanized Steel - Bolt On - Qty 1
- Boat Trailer Parts
- Tie-Down Anchors
- Tie-Down Anchor Brackets
- 1-15/16 Inch Wide
- 4 Inch Long
- CE Smith
more information >
Continue Researching
- Q&A: Best Lug Nuts for 2021 Keystone Cougar 29RKS
- Q&A: How Do Safety Chains of Andersen Ultimate Safety Chain Kit Attach to Fifth Wheel Rail
- Q&A: California Required Safety Chains for Andersen Ultimate Hitch
- Q&A: Will The DeeMaxx Disc Brake Caliper Work as a Replacement With Tie Down Disc Brakes?
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Replacement Leaf Spring for 7k Axle that is 25-1/4 inch
- Q&A: How to Identify Axles and Can Leaf Springs With Higher Capacity Be Installed
- Q&A: Replacement Master Cylinder and Reverse Lock Out Solenoid, Titan Model 10 Trailer Brake Actuators
- Article: How to Choose a Trailer Hitch Coupler
- Article: Boat Trailer Guides: Which are the Best?
- Article: How to Launch a Boat from a Trailer (And Load it Back Up)
- Article: Trailer Lighting Requirements
- Article: Trailer Tire Sizing