Fresh Water Tank 90-Degree Drain Elbow Installation
Updated 05/13/2021 | Published 05/11/2021 >
Question:
can i glue to a white fresh water tank, need to add a vent to my new tank
asked by: ERIC E
0
Expert Reply:
If you're just cutting a hole in the tank and adding the Valterra 90-Degree Drain Elbow - Flange x 3/4" Barb - Polypropylene Item # RF839 you could do so by sliding it through the hole and using the lip to keep it from coming out and then caulking around the outside and inside for a water-tight seal with some non-toxic caulking from your local hardware store.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Fitting for Valterra ABS Fresh-Water Tanks - 90-Degree Elbow - Flange x 3/4" Barb
- RV Fresh Water
- Supply Water
- Fittings
- Plastic
- Elbow Coupler
- 3/4 Inch
- Barb
- Valterra
more information >
Continue Researching
- Q&A: What are the Hose Sizes on the Seaflo Fresh Water Electric RV Toilet E95CR?
- Q&A: How Do the SeeLeveL RV Holding Tank Monitoring Sensors Work for Propane Tanks
- Q&A: Propane Gauge Recommendation for Four 100 lb Propane Tanks
- Q&A: Troubleshooting a Lippert Level-Best Leveling System that Suddenly Stopped Working
- Q&A: Pigtail Replacement for 2009 Jayco Jay/flight G2TT
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Q&A: Adapter to Drain Gray Water Tank Using a Regular Garden Hose
- Q&A: Height of Valterra 90-Degree Drain Elbow Connector

