Using a Pintle Hook and Lunette Ring Assembly and Coupler and Trailer Hitch Ball
Updated 03/22/2013 | Published 03/20/2013 >
Question:
I have the pintle hook as described above using a ball and hitch assy. I want to have the pintle and lunnette as backup. Can I assemble the lunnette ring onto a ball assy adapter?
asked by: Tom H
Helpful Expert Reply:
I do have a solution that I think will work for you. If you can mount a Bulldog channel to the front of the trailer, # BDAC5000300, then you could use a coupler like # BDA200C0317, AND use lunette ring # 337B16137 when needed.
We also have the pintle hook combo # TR63041 for a 2 inch ball, # TR63042 for a 2-5/16 inch ball to adapter the vehicle end of the set up.
Product Page this Question was Asked From
Curt Lunette Ring - Flat Plate Mount - 2-1/2" Diameter - 35,000 lbs
- Lunette Ring
- Coupler with Bracket
- Bolt-On
- 35000 lbs GTW
- 2-1/2 Inch Lunette Ring
- CURT
more information >
Continue Researching
- Q&A: Power Mountain Tallboy PM75ZR Jack Stand for Lifted Ford F-150
- Q&A: Bolt Pattern of Buyers Products 3" I.D. Heavy-Duty Forged 4-Bolt Mount Lunette Ring # 337BDB1385
- Q&A: Recommended Hitch for a 2025 Subaru Forester Hybrid
- Q&A: Bolt Torque for Curt Lunette Ring - Flat Plate Mount - 2-1/2" Diameter - 35,000 lbs
- Q&A: Curt # C48560 vs Buyers Products # 337BDB1394 Lunette Ring Comparison
- Q&A: Recommended Replacement Strut for a Snowmobile Trailer
- Q&A: Width of Lippert LC733932 Solid Step RV Steps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams

